Username:   Not registered yet?
Password:   Forgot password?
iB Code Einmal klicken um den Tag zu öffnen, nochmal klicken zum Close

Top Smilies

HTML ist on für dieses Forum

IkonCode ist on für dieses Forum



Would you like to add your signature?
Do you want to be informed about answer by email?
Do you want to activate emoticons in your post?

Review of postings for Disconnecting Pins? (the latest posts first)
ocinside Erstellt: 19:34 am 10. Juni 2003
For the Pin-Mod guide it's not necessary to disconnect any pin when you set your the multiplier control in your BIOS to AUTODETECT.
If you don't have something like this in your BIOS, there's no need to do so

The state of LOW or HIGH is done when you connect the Pin to VSS or VCC, this is what my interactive Pin-Mod guide do, so there's no need to cut anything :thumb:

Oh and Vcore Mod ... hmmm don't like to say too much, yet
NWD Erstellt: 22:02 am 8. Juni 2003

the bridge has a mor or less direct connection to a pin

disconnecting a pin is very difficult..

i have seen a very dangerous method, you can open your Socket and remove the "pins" in the socket..

but this is an permanent method and you can easily damage your mainboard ..

i would  Disconnect per Bridges and Connect via Pins

for cutting just take a very sharp knife or an scalpell
Crabby Guy Erstellt: 9:40 am 8. Juni 2003
I think I understand that connecting pins is just like connecting bridges.  However, how do I disconnect pins (insteading of cutting bridges)?

Also, can I change Vcore this way?